Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions télécharger pdf (Page 19)

A07218

Fig. 13 -- Cover on Equipment Control Module

14. Turn on power to equipment. On power up, all display segments will

light for 5 sec. For the next 5 sec a 2--digit code appears on large display

which identifies AC/HP Control configuration. Refer to Option 33.

a. AC — 1--stage air conditioner, AC, HP

b. HP — 1 --stage heat pump, HP only

c. H — heating only system, AC, HP

d. C — cooling only system, AC, HP

Single--Piece Installation

The following steps should be followed for the installation of the single--piece

configuration.

1. Remove cover from Equipment Control Module by pressing the two tabs

on the bottom edge and pulling away . Route wires through large hole in

Equipment Control Module. Level Equipment Control Module against

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Pas de commentaire

Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions Page 19