Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions télécharger pdf (Page 10)

UNIT DAMAGE HAZARD

Failure to follow this caution may result in equipment damage

or improper operation.

Improper wiring or installation may damage AC/HP Control.

Check to make sure wiring is correct before proceeding with

installation or turning on power.

CAUTION

1. Turn off all power to equipment.

2. If an existing thermostat is being replaced

a. Remove existing thermostat from wall.

b. Disconnect wires from existing thermostat, 1 at a time.

c. As each wire is disconnected, record wire color and terminal marking.

d. New or additional wire may be needed to accommodate added hu-

midity outputs.

e. Discard or recycle old thermostat.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Pas de commentaire

Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions Page 10