Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions télécharger pdf (Page 18)

A07227

Fig. 12 -- Standoff

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 7, 8 and 9.

13. Snap cover over top of Equipment Control Module. See Fig. 13.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Pas de commentaire

Bryant NON-PROGRAMMABLE THERMOSTAT Manuel d'instructions Page 18