Bryant PREFERREDT A07045 Manuel d'utilisateur télécharger pdf (Page 19)

A07227

Fig. 12 -- Standoff

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the Thermidistat Control mounting base. If wires are con-

nected incorrectly, the Display Module will not operate. See Fig. 7, 8 and

13. Snap cover over top of Equipment Control Module. See Fig. 13.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Pas de commentaire

Bryant PREFERREDT A07045 Manuel d'utilisateur Page 19